One Eight Digit Large Displays, Two Large 5 Digit, Red and Green Stop lights Sign (36Hx48W)

With so many programming options you can make this counter display just about anything.  The most common use for this counter is to track safe hours worked, but we've had people use this counter to track days until a project deadline, number of environmental incidents, static price display, and many more. The logic is simple.  Tell the sign how often you want to count, what direction to count, and how much to count by each time it counts.  Then simply set a current count, and the counter will begin following your instructions.  The configuration is stored in flash memory so if the power goes out, you won't need to reconfigure it.

Programming Options Count up or count down or turn automatic counting off and the display will only show the number you set it to. Set the brightness level from dim to blinding (5 levels of brightness). Count action can be configured to occur every second, minute, hour, day, week, or month. Limit counting to certain days.  For example you might only want to count Monday to Friday and not count on weekends. Configure the display to count by any number from 1 to 99 and each time the counter counts it will increment or decrement by that number. Decimal point location can be set to light the decimal point at any location

By default these displays use only the decimal point, but the full comma can be enabled or disabled by setting a jumper on the back of the displays.

We source each of these LED stoplight modules from a traffic signal company so each is 8" in diameter and very visible!  The lights are controlled with our own stoplight controller module which allows you to set each light to on off or flashing.  All control methods are supported by this controller so you can configure the light manually with a pushbutton on the controller, with the IR remote, or via our network controller board.

Configurability
9 levels of brightness 
Set Light On, Off or Flashing
Three different flashing speeds

For a walkthrough of how to program your stoplight, check out this video.

We source each of these LED stoplight modules from a traffic signal company so each is 8" in diameter and very visible!  The lights are controlled with our own stoplight controller module which allows you to set each light to on off or flashing.  All control methods are supported by this controller so you can configure the light manually with a pushbutton on the controller, with the IR remote, or via our network controller board.

Configurability
9 levels of brightness 
Set Light On, Off or Flashing
Three different flashing speeds

For a walkthrough of how to program your stoplight, check out this video.

With so many digits and programming options you can make this counter display just about anything.  We've had people use this counter to track safe miles driven for an entire fleet, safe man hours worked, seconds until a project deadline, and many more. The logic is simple.  Tell the sign how often you want to count, what direction to count, and how much to count by each time it counts.  Then simply set a current count, and the counter will begin following your instructions.  The configuration is stored in flash memory so if the power goes out, you won't need to reconfigure it.

Programming Options Count up or count down or turn automatic counting off and the display will only show the number you set it to. Set the brightness level from dim to blinding (5 levels of brightness). Count action can be configured to occur every second, minute, hour, day, week, or month. Limit counting to certain days.  For example you might only want to count Monday to Friday and not count on weekends. Configure the display to count by any number from 1 to 65,535 and each time the counter counts it will increment or decrement by that number. Decimal point location can be set to light the decimal point at any location, or to light the decimal points at thousandth's separator locations

Display Modes This display can be configured to show the count in a couple different ways, or you can choose to use it as a clock or calendar display.

Current Count - Shows the current count
Clock - Shows the current time in HH MM SS format
Calendar - Shows the current date in DD-MM-YY format
Clock/Calendar - Alternate between Cock and Calendar display every 30 seconds