Scoreboard with 8 and 4 digit large Displays and Scrolling Message (48Hx72W)

With so many programming options you can make this counter display just about anything.  The most common use for this counter is to track safe days worked, but we've had people use this counter to track days until a project deadline, number of environmental incidents, static price display, and many more. The logic is simple.  Tell the sign how often you want to count, what direction to count, and how much to count by each time it counts.  Then simply set a current count, and the counter will begin following your instructions.  The configuration is stored in flash memory so if the power goes out, you won't need to reconfigure it.

Programming Options
Count up or count down or turn automatic counting off and the display will only show the number you set it to. Set the brightness level from dim to blinding (5 levels of brightness). Count action can be configured to occur every second, minute, hour, day, week, or month. Limit counting to certain days.  For example you might only want to count Monday to Friday and not count on weekends. Configure the display to count by any number from 1 to 99 and each time the counter counts it will increment or decrement by that number. Decimal point location can be set to light the decimal point at any location

By default these displays use only the decimal point, but the full comma can be enabled or disabled by setting a jumper on the back of the displays.

For a walkthrough of how to program your numeric display, check out this video.

With so many digits and programming options you can make this counter display just about anything.  We've had people use this counter to track safe miles driven for an entire fleet, safe man hours worked, seconds until a project deadline, and many more. The logic is simple.  Tell the sign how often you want to count, what direction to count, and how much to count by each time it counts.  Then simply set a current count, and the counter will begin following your instructions.  The configuration is stored in flash memory so if the power goes out, you won't need to reconfigure it.

Programming Options Count up or count down or turn automatic counting off and the display will only show the number you set it to. Set the brightness level from dim to blinding (5 levels of brightness). Count action can be configured to occur every second, minute, hour, day, week, or month. Limit counting to certain days.  For example you might only want to count Monday to Friday and not count on weekends. Configure the display to count by any number from 1 to 65,535 and each time the counter counts it will increment or decrement by that number. Decimal point location can be set to light the decimal point at any location, or to light the decimal points at thousandth's separator locations

Display Modes This display can be configured to show the count in a couple different ways, or you can choose to use it as a clock or calendar display.

Current Count - Shows the current count
Clock - Shows the current time in HH MM SS format
Calendar - Shows the current date in DD-MM-YY format
Clock/Calendar - Alternate between Cock and Calendar display every 30 seconds

This outdoor scrolling message sign is brighter and bigger than our standard scrolling message sign.  Instead of an IR remote, the scrolling message sign is programmed using an ethernet connection and software on a connected PC.

Physical Display Area: 320mm x 1600mm  (6.3" x 63")

Resolution DPI: 16 pixels X 160 pixels

NOTE: Ethernet control of the scrolling message is REQUIRED. signs shipped with this component will include a network controller by default. To make updates to the display you must access the sign via the webpage provided by the network controller.  This will require an ethernet connection to the sign.